Pocket Door Hardware Instructions

Do not use jambs with dado s.

Pocket door hardware instructions.

Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw. Bumpers pads slides door hardware home hardware household hangers knobs pulls. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door. Nail the end plate to the wall studs.

High and 1 3 4 in. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased. The everbilt 36 in. If needed use a hand saw to cut the track that came with your pocket door hardware so that it s 1 8 inch shorter than the opening.

You may be able to find pocket doors at lumberyards too. Higher than the door panel height. Install the track according to the thickness of the header. Répétez l opération avec l autre roulette et attache de porte.

Pocket door frame set the everbilt 36 in. Fasten split header on 1121 lock lever side with screws for future door removal or adjustment. Purchase a pocket door kit at a hardware store. For doors inch thick install the track flush with the header.

Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives. Once the frame is in place it s time for the pocket door installation. This kit should contain the door split studs that allow the door to retract into the wall a track on which the door runs into the wall and door hardware. Johnson hardware pocket door hardware.

Vertically and the door rough opening should be 4 in. Install finished jambs split header and casing as shown. Item 264668 model n 7015n 7015. Its door panels are adjustable up to 5 8 in.

1 574 293 5664 m f 8 00am 5 00pm est. Door hardware knobs pulls supports catches latches all categories. Pocket door frame set is designed for use with doors up to a maximum of 80 in. Prime line 2 pack 1 125 in plastic pocket door bottom guide.

Check that the track is level so that the door rolls easily. The door rides through a channel made by what are called split studs these studs function like regular wall studs but are metal wrapped and form a hollow channel in the middle for the pocket door to pass through.